I am trying to upgrade a very old PB app. It run under PB 7. The reason it is running under PB 7 is because all previsous attempts to migrate it resuted in PDFs that were larger than 1 page in size. Whereas they are 1 page in size under PB7.
It is my understanding that resizing the report before convertint it to a PDF has been tried all no avail. Any suggestions or help would be greatly appreciated as the remaining 5 executables must be upgraded to PB 10.5 ASAP.
PB Upgrade problem
Problem restated
With the most current PDF converter I have the following problem when trying to upgrade a PB app. from PB7 to PB 10.5 When run against a report created in PB 7 that 8.5 x 11 the report comes out of pdf creator as 8.5 x 11. However, after upgrading to any newer version of PB the PDF is larger that 8.5 like somewhere in the neghborhood of 9 x 11. Resizing of the report before submitting to PDF conversion has no effect. the resulting PDF is still approximately 9 x 11.
Does that make it clearer?
Does that make it clearer?
Format change
The printer and paper have not changed...... Why would they????? I guess I am confused by the response. I compile the program on PB7 and print to printer X and the report is 8.5 inches wide I compile the program on PB 10.5 and the report is 8.85 inches wide on printer X.
If I don't convert to PDF then it prints out fine as 8.5 x 11 in both cases. But as soon as I convert to PDF when using PB 10.5 it ends up 8.85 x 11!!! Does that sound like a format issue????
If I don't convert to PDF then it prints out fine as 8.5 x 11 in both cases. But as soon as I convert to PDF when using PB 10.5 it ends up 8.85 x 11!!! Does that sound like a format issue????