Hi When I upgrade a client from 2.08 with a working serial number the 2.10 client looses the serial number (in properties configuration).
I can't click the .. box to add the info as the whole configuration tab is unresponsive.
If i try a 2.10 fresh install I am not asked for a serial number so I tried the install.ini lines below
[Default]
PrinterName="Amyuni PDF Converter"
Licensed to="Company Name"
Activation code="XXXXXXXX-XXXX"
XXXXXXXX-XXXX being our site license serial number.
Can someone please help with this ASAP.
rgds
Phil
2.08 upgrade to 2.1 or 2.1 base install looses serial number
-
- Posts: 5
- Joined: Tue Oct 01 2002
Hello,
Installing version 2.1 of the driver is a little bit different than installing 2.08. Instead of the serial number you need to use an Activation Code that you received from us upon upgrading to 2.1
You can enter the Activation Code and License To information in the Amyuni Tech tab under the Printer Properties.
If you didn't receive an Activation Code please contact our Support Department support@amyuni.com
Hope this helps !
Installing version 2.1 of the driver is a little bit different than installing 2.08. Instead of the serial number you need to use an Activation Code that you received from us upon upgrading to 2.1
You can enter the Activation Code and License To information in the Amyuni Tech tab under the Printer Properties.
If you didn't receive an Activation Code please contact our Support Department support@amyuni.com
Hope this helps !
-
- Posts: 5
- Joined: Tue Oct 01 2002