Beginner question concerning viewing a PDF using Creator

If you are a Power Builder developer and have any questions about using our products from Power Builder here is the place to post them.
Post Reply
markmazza
Posts: 3
Joined: Tue May 03 2005
Location: Eugene

Beginner question concerning viewing a PDF using Creator

Post by markmazza »

It was simple instantiating and printing an existing PDF from PDF Creator. And now I'm simply trying to view an existing PDF from PDF Creator. I can't find any view method except one called DrawCurrentPage. Can someone provide me with a few lines of code to just display an existing pdf using just the PDFCreativeX.dll?

Thank you kindly...
Mark
Joan
Amyuni Team
Posts: 2799
Joined: Wed Sep 11 2002
Contact:

Post by Joan »

Hello,

To view a pdf file using the PDF Creator you need to have the PDF Creator control added to your forum.

You need to use the Open or OpenEx methods of the control to open a pdf document.

If you wish please downlaod our Powerbuilder technical note from: http://www.amyuni.com/en/support/technotes.html

Hope this helps.
Joan
Amyuni Team
Posts: 2799
Joined: Wed Sep 11 2002
Contact:

Post by Joan »

Hello,

To view a pdf file using the PDF Creator you need to have the PDF Creator control added to your forum.

You need to use the Open or OpenEx methods of the control to open a pdf document.

If you wish please downlaod our Powerbuilder technical note from: http://www.amyuni.com/en/support/technotes.html

Hope this helps.
Post Reply